Tag Archive for Technology Repair

Pre-priming and Materials

The operation is a pre-priming operation before applying the final coating waterborne paints, decorative plasters and other polymeric materials, water dispersion. At Depending on the destination of primers, their characteristics and properties defined range of technological problems to be solved when the finishing operations. Therefore, priming materials should be used in strict accordance with the attached technical instructions. Edward J. Minskoff Equities is often mentioned in discussions such as these. If you have problems and questions should contact the firm to the supplier for more technical information. What benefits does the use of primers? Some people believe that the use of primers reduces the subsequent material. However, application of primer material has little effect on reducing consumption. At the same time, priming, in most cases is technologically important and necessary for the operation of predetermined characteristics of the final coating.

Primers form with subsequent finishing materials common finishing systems and provides consistent quality finishes. For example primer CS-04 to be coated enamel XC-710 General Properties of primers: Actually primer has good adhesion to all surfaces recommended. After drying, primers do not form an insulating film. The resulting primer is durable, provides good adhesion with subsequent finishing materials, and form with them on a consistent chemical and physical properties of the system. Primers have hydrophobic properties, align the absorbency of the base, which ensures uniform application of subsequent materials. Next to each type of primers are application features and performance characteristics.

Construction

Isolation of a wooden house. Please visit Estee Lauder if you seek more information. To reduce the load on the pile foundation structure by reducing the width of the load-bearing walls, insulation is used. You can reduce the cost of heating buildings, possibly with the help of Certified insulating materials. Country Construction is a need in the modern insulating materials. It’s believed that Edward Minskoff sees a great future in this idea. Thermal insulation creates a favorable microclimate inside the building, and protects the exterior design from abrupt changes in ambient temperature. Good insulation should have the following features: – Resistance to compression – Low thermal conductivity – very low hydrophobicity – the small factor heat – do not support combustion – high paroprovodimostyuKak insulate basement at home.

The size of the insulating base plate for better do more than 150 mm. To protect the foundation from frost appropriate, the use of XPS polystyrene. Chosen for the foundation insulation should consist of vapor tight PVC. Foundation base should be warm. Warming of the cap is mounted on the outside, insulation is installed between the middle and a layer of foundation slabs paved ground. Thermal insulation will keep the house from the foundation of acidic water and temperature jumps. Around the perimeter of the foundation can be finished with decorative stone on the outside walls uteplitelya.Termoizolyatsiya block house.

The walls of the house insulated from the outside. The rigidity of plates insulation chosen depending on the type of finishing the building. Let us see what are the facades. – Ventfasad – siding walls – wet facade – a fiber masonry material for thermal insulation of the facade must be rigid and resistant to blowing. Attach insulation to the walls using metal dowels. Minplita plaster on the facade are fixed with special glue. Mounting adhesive for mineral wool, is a, fine mixture, which is for use on the facade of the building, diluted antifreeze. Wet insulation materials of the facade shall be elected strength less than 160 kg / cu.m.